This simple kit will raise the s

These air filter covers can be added to any Mustang Cowl and will enhance its scale appearance. They can be added during construction or to finished cowls and make a great combination when used with my exhaust kits.

This is what comes in the kit surface mount kit ... the rubber bands are for wrapping
the covers around a cylinder to pre-curve the covers

Drawn using the original NAA microfilm, these covers are laser cut from aircraft grade plywood (all 64 holes!). They are easily pre-curved and can be covered with self adhesive aluminum tape (supplied in the kit and shown in the middle cover above), or painted to suit. The area of the cowl behind the holes can be opened up for additional engine compartment venting (roughly 1-3/4 sq in total in the 1/5 scale).

This photo shows a cover mounted on the Pacific Scaled Aircraft replacement cowl for the Top Flite GS Mustang

Available in these scales ... 1/7 1/6 1/5 1/4.5

Two kit styles are available ...

SURFACE MOUNTED

This kit's covers are cut from 1/64" plywood and are designed to mount on the surface of the cowl. Each kit comes with two covers, self adhesive 0.005" aluminum foil, installation instructions and a positioning template.

$6.00 including postage to US destinations

FLUSH MOUNTED

These covers are cut from 1/32" plywood and are designed to mount flush with the surface of the cowl. Each kit comes with two covers, a pair of backing plates, spacers and fiberglass cloth, self adhesive 0.005" aluminum foil, installation instructions and a positioning template. More work to install than the flush mounted units, these are the ultimate in scale realism.

$10.00 including postage to US destinations

Please use the CONTACT link below to order

HOME CONTACT GALLERY ORDERING INSTALLATION NEW PROJECTS
DETAILING IDEAS KIT CONTENTS SAMPLE INSTRUCTIONS KITS