PSA Kit Contents

This simple kit will raise the stab on your Top Flite GS 1/5 Scale Mustang RTC or ARF 5/8" and put it at its proper scale location on the fuselage. (This kit is not needed on builder kits whose stab is in the correct position.)

Note that the top line of the fuselage intersects the the stab at about its thickest point ... compare that to the stab position on your kit

The kit consists of a jig to mark the new stab top outline on the sides of the fuselage, two laser cut balsa saddle filler pieces and a pair of laser cut plywood doublers to reinforce the new saddles. Instructions with diagrams are included. Installation takes very little time. Note that you will have to either relocate the push rod exits or use an internal elevator linkage.

Using the kit makes raising the stab straightforward while insuring the stab incidence is left unchanged

BEFORE

AFTER

Photos courtesy Chris Plash

$12.50 shipped via Priority Mail to US destinations
email me to order using the CONTACT link below

HOME CONTACT GALLERY ORDERING INSTALLATION NEW PROJECTS
DETAILING IDEAS KIT CONTENTS SAMPLE INSTRUCTIONS KITS